If you have been reading about secondary drying and want a single page that covers the useful parts, this is it: definitions, context, how it is studied, and the questions that come up repeatedly.
Updated 2025-10-10. Numbers and descriptions here follow the published literature rather than marketing material.
Equipment for lyophilization includes a vacuum chamber, temperature-controlled shelves, a condenser, and a vacuum pump. A refrigeration system cools the shelves and condenser below the product's freezing point. Process monitoring often uses Pirani and capacitance manometers, thermocouples, and resistance sensors. Cycle development balances product quality with time and energy use. Some products are annealed during freezing to improve crystallization of bulking agents. Open questions remain about scaling cycles between laboratory, pilot, and production freeze-dryers.
Lyophilization, also called freeze-drying, removes water from a frozen material by sublimation under reduced pressure. The process begins with freezing, which converts free water into ice and may also produce a glassy phase. Primary drying then lowers chamber pressure so ice sublimes directly to vapor without passing through a liquid stage. Secondary drying raises the temperature modestly to remove bound water. The result is a porous, dry solid that usually reconstitutes quickly. Each stage influences pore structure, residual moisture, and stability.
The physics of lyophilization depends on phase boundaries and heat and mass transfer. During primary drying, heat supplied to the product must equal the latent heat of sublimation, while water vapor moves through the drying cake to the condenser. If shelf temperature or pressure is set too high, the ice front can exceed the collapse temperature, causing meltback or pore collapse. If conditions are too cold, drying slows and costs rise. Formulation excipients, vial geometry, and freezing rate alter these limits.
A typical cycle begins with freezing, sometimes including an annealing step to control ice crystal size. Freezing conditions influence the pore network that later allows vapor escape. During primary drying, shelf temperature and chamber pressure are set so heat enters the product while its temperature stays below the collapse or eutectic point. Secondary drying then raises the shelf temperature to desorb bound water and lower residual moisture. Cycle design depends on formulation, fill volume, container type, and equipment capability.
The physics of lyophilization couples heat transfer, mass transfer, and phase behavior. Sublimation requires a vapor pressure difference between the ice front and the chamber, and the dried layer adds resistance to vapor flow. Amorphous formulations are characterized by a glass transition temperature of the maximally freeze-concentrated solute, often denoted Tg'. Crystalline bulking agents can provide structure, while amorphous excipients stabilize labile components. Open questions remain about spatial heterogeneity, edge effects, and how laboratory cycles scale to production.
| Property | Value | Notes |
|---|---|---|
| Common synonyms | Freeze-drying; lyophilisation; cryodesiccation | Regional spelling and historical terms. |
| Primary drying pressure | 0.05-0.5 mbar (5-50 Pa) | Kept below the triple point of water; product-specific. |
| Shelf temperature range | -40 to +40 °C | Freezing, primary, and secondary stages use different set points. |
| Cycle duration | 12-72 hours | Depends on fill volume, formulation, and equipment. |
| Condenser temperature | -50 to -80 °C | Must remain below the product's ice temperature. |
A freeze-dryer consists of a vacuum chamber, temperature-controlled shelves, a condenser, and a vacuum pump. Vials, ampoules, or bulk trays hold the product during the cycle. The condenser traps water vapor as ice at a temperature lower than the product. Cycle development balances shelf temperature, chamber pressure, and time. Scale-up can be difficult because heat and mass transfer change with equipment size, so process analytical tools and conservative validation are often used.
Lyophilization is a dehydration technique in which a product is frozen and the solvent is removed under reduced pressure. The low pressure allows ice to sublimate directly into vapor without passing through a bulk liquid phase. This differs from conventional drying, where heat drives evaporation and can damage heat-sensitive structures. The process is used for biological materials, pharmaceutical formulations, and some foods. Its main advantage is preservation of porous structure and rapid reconstitution.
Freeze-drying is used for materials whose activity or structure depends on low temperature and low water content. Examples include certain biologics, diagnostic reagents, starter cultures, coffee, and porous inorganic precursors. The dried product forms a cake whose porosity aids rapid wetting and dissolution. Main drawbacks are high energy use, long cycle times, and sensitivity to formulation and equipment variation. Questions remain about how freezing rates and ice morphology affect batch uniformity, especially when moving from laboratory to production scale.
Lyophilization, also called freeze-drying, is a dehydration process in which a solvent, usually water, is frozen and then removed by sublimation under reduced pressure. The method preserves heat-sensitive materials that would degrade in conventional drying. Large-scale use grew during the mid-twentieth century for blood plasma and antibiotics, and it later expanded to vaccines, enzymes, foods, and advanced materials. The process produces a dry, porous solid that usually reconstitutes rapidly. It is distinct from simple evaporation because the solvent bypasses the liquid phase during primary removal.
23090Th + n → 23190Th + γ β−→25.5 h 23191Pa ( α→3.28 × 104 y 22789Ac ) 23191Pa + n → 23291Pa + γ β−→1.3 d 23292U α→69 y 232U by itself is not particularly harmful, but quickly decays to produce the strong gamma emitter 208Tl. (232Th follows the same decay chain, but its much longer half-life means that the quantities of 208Tl produced are negligible.) These impurities of 232U make 233U easy to detect and dangerous to work on, and the impracticality of their separation limits the possibilities of nuclear proliferation using 233U as the fissile material. 233Pa has a relatively long half-life of 27 days and a high cross section for neutron capture. Thus it is a neutron poison: instead of rapidly decaying to the useful 233U, a significant amount of 233Pa converts to 234U and consumes neutrons, degrading the reactor efficiency. To avoid this, 233Pa is extracted from the active zone of thorium molten salt reactors during their operation, so that it does not have a chance to capture a neutron and will only decay to 233U. The irradiation of 232Th with neutrons, followed by its processing, needs to be mastered before these advantages can be realised. Because this requires more advanced technology than the uranium and plutonium fuel cycle, research continues in this area. Others cite the low commercial viability of the thorium fuel cycle: the international Nuclear Energy Agency predicts that the thorium cycle will never be commercially viable while uranium is available in abundance—a situation which may persist "in the coming decades".
Disagreements arose, because the brigand wanted to assault Platì and take revenge on the local liberals, unlike Borjes, who eventually gave in. The unsuccessful assault took place on September 17. The brigands and legitimists were repelled by the National Guards and a regular army unit. This failure soon ended their collaboration. On October 20 Borjes traveled to Basilicata to join his forces with those of Carmine Crocco. They achieved successes, but not the final objective, as the brigand leader refused to turn his men into a regular army. Noting the failure of the plan, the Catalan general attempted to travel to Rome to report to the Bourbon ruler. He was captured in Tagliacozzo and shot on 8 December 1861. Borjes' failure did not end brigandage, which continued with greater virulence. For this reason, the first Minghetti government promulgated the Pica law on 15 August 1863. It was a regulation that suspended constitutional guarantees for the southern provinces and imposed a state of siege. It delivered brigands to military tribunals, without appeal or defense. In Calabria the law was applied in Citeriore and Calabria Ulteriore Seconda, while the Reggio area, as was the area around Naples and part of Apulia were exempted. The Pica law remained in force until 31 December 1865, and contributed to eradicating banditry, albeit with repressive methods and without resolving the southern territories' social and economic problems. An underlying issue was latifundium (estates), which were in the hands of a few economic and political elites.
=== Civil society === Reactions also came from European civil society organisations. Transparency International described the incident as "the most egregious case" of alleged corruption the European Parliament has ever seen. The founder of the Good Lobby commented that "[w]hatever its final outcome, [the] Qatar 'corruption' scandal has unveiled an inconvenient, and for most Europeans already obvious, truth. Money does buy influence in the EU", and that "[t]he EU Parliament and most of its members have historically resisted stricter integrity rules and [an] effective enforcement system." As news broke of the investigation, the honorary board of the implicated NGO, Fight Impunity, resigned en masse. The board members included high-profile European policymakers including Federica Mogherini (former EU High Representative in the Juncker Commission), Bernard Cazeneuve (formerly Prime Minister of France), Dimitris Avramopoulos (former EU Commissioner for Migration, Home Affairs and Citizenship in the Juncker Commission), Cecilia Wikström (former MEP) and Emma Bonino (former EU Commissioner for Health and Consumer Protection in the Santer Commission). The honorary board has no executive or managerial role, so there is no suspicion or accusations against any member of the board. Visentini originally voluntarily stood down temporarily as president of the International Trade Union Congress but a specially convened Extraordinary Meeting of the General Council voted to suspend him of all of his duties.
=== Relations === The pelvic cavity of the true pelvis has the pelvic floor as its inferior boundary (and the pelvic brim as its superior boundary). The perineum has the pelvic floor as its superior boundary. Posteriorly, the pelvic floor extends into the anal triangle.
Sources: en.wikipedia.org
Carlos Manuel de Céspedes was either initiated or introduced to the concept of Freemasonry during his time studying in Spain the 1840's, but as well, he studied what secret societies he could of the entire Mediterranean region from Syria to Turkey on his travels. After the death of Narciso López, in 1851, de Céspedes wrote the original version of La Bayamesa with the poet José Fornaris. In 1867, de Céspedes joined Estrella Tropical Lodge No. 19, in the town of Bayamo. Most records indicate that this was his initiation. On August 13, 1867, a meeting was held at Estrella Tropical Lodge No. 19 to discuss the revolution against the Spanish. After the meeting, Francisco Maceo Osorio turned to Perucho Figueredo, and said to him: "...now it's your turn, who are a musician, to compose our own Marseillaise." Figueredo finished the instrumental composition the next day, on August 14. On October 20, 1868, Figueredo finished the lyrics of the current version of Cuba's national anthem as the revolutionary troops entered Bayamo.
== Government action == The FDA filed a complaint for injunction in 2014, alleging that the company QLaser PMA was marketing its devices as being able to treat "over 200 different diseases and disorders," including cancer, cardiac arrest, deafness, diabetes, HIV/AIDS, macular degeneration, and venereal disease. This case resulted in a permanent injunction against the manufacture, marketing, sale, and distribution of those devices in 2015. In 2017, the owner of QLaser, Robert Lytle, and two of QLaser's distributors were charged with a criminal conspiracy to commit fraud. Lytle pleaded guilty to one count of conspiracy to introduce misbranded medical devices into interstate commerce with the intent to defraud and mislead, and one count of criminal contempt in January 2018. Lytle was sentenced to serve 12 years in prison and made an initial restitution payment of $637,000. Lytle's conspirators were sentenced to 24 months and 15 months, respectively.
Copolymers are classified either as statistical copolymers, alternating copolymers, block copolymers, graft copolymers or gradient copolymers. In the schematic figure below, Ⓐ and Ⓑ symbolize the two repeat units.
=== Crime === Belize has moderate rates of violent crime. The majority of violence in Belize stems from gang activity, which includes trafficking of drugs and persons, protecting drug smuggling routes, and securing territory for drug dealing. In 2023, 87 murders were recorded in Belize, giving the country a homicide rate of 19.7 murders per 100,000 inhabitants, lower than the neighbouring countries of Mexico and Honduras, but higher than Guatemala and El Salvador. Belize District (containing Belize City) had the most murders by far compared to all the other districts. In 2023, 66% of the murders occurred in the Belize District. The violence in Belize City (especially the southern part of the city) is largely due to gang warfare. In 2023, there were 34 reported cases of rape, 170 robberies, 628 burglaries, and 118 cases of theft.
Treponema pallidum, formerly known as Spirochaeta pallida, is a microaerophilic, gram-negative, spirochaete bacterium with subspecies that cause the diseases syphilis, bejel (also known as endemic syphilis), and yaws. It is known to be transmitted only among humans and baboons. T. pallidum can enter the host through mucosal membranes or open lesions in the skin and is primarily spread through sexual contact. It is a helically coiled microorganism usually 6–15 μm long and 0.1–0.2 μm wide. T. pallidum's lack of both a tricarboxylic acid cycle and processes for oxidative phosphorylation results in minimal metabolic activity. As a chemoorganoheterotroph, Treponema pallidum is an obligate parasite that acquires its glucose carbon source from its host. Glucose can be used not only as a primary carbon source but also in glycolytic mechanisms to generate ATP needed to power the bacterium given its minimal genome. The treponemes have cytoplasmic and outer membranes. Using light microscopy, treponemes are visible only by using dark-field illumination. T. pallidum consists of three subspecies, T. p. pallidum, T. p. endemicum, and T. p. pertenue, each of which has a distinct related disorder. The ability of T. pallidum to avoid host immune defenses has allowed for stealth pathogenicity. The unique outer membrane structure and minimal expression of surface proteins of T. pallidum has made vaccine development difficult. Treponema pallidum can be treated with high efficacy by antibiotics that inhibit bacterial cell wall synthesis such as the beta-lactam antimicrobial penicillin-G.
Sources: en.wikipedia.org
Simple drying usually removes water by evaporation from a liquid or solid, often with heat. Lyophilization first freezes the material and then removes ice by sublimation under vacuum. This avoids prolonged exposure to liquid water and high temperatures.
Reduced pressure lowers the boiling point of water and allows ice to sublime at temperatures below freezing. It also helps remove water vapor from the product toward the condenser. The exact pressure is chosen to stay below the triple point of water.
No. Materials with low solids content or high volatile solvents may form weak or collapsed cakes. Some proteins and cells require stabilizers to survive freezing and drying stresses. Feasibility depends on formulation and process design.
Freezing only converts liquid to solid. Lyophilization adds vacuum and controlled warming so frozen solvent sublimes, leaving a dry porous solid. The two steps are related but not interchangeable.