The short version of Lyophilization fits in a sentence. The long version — which is the one that helps — is below.
This page was last updated on 2026-07-07 and is reviewed periodically as new material appears.
Regulatory expectations for lyophilized products focus on consistent manufacture and documented stability. Batches are often monitored for moisture, appearance, potency, and sterility where applicable. Process parameters such as shelf temperature, chamber pressure, and drying time are recorded and controlled within validated ranges. Open questions remain about how best to predict long-term stability from short accelerated studies, especially for complex biologics. Variations in freezing rate and ice crystal size can produce differences that are not always visible but may affect performance.
After drying, a lyophilized product is usually sealed under vacuum or an inert gas to limit moisture uptake. Residual water content is measured because small changes can alter chemical stability and cake appearance. Storage temperature depends on the material; many biological products are kept at 2–8 °C, while some require −20 °C or colder. Exposure to ambient humidity during handling can cause the porous solid to absorb water and collapse. Container closures and stoppers are therefore selected for low moisture transmission and compatibility.
In practice, lyophilization is slower and more energy intensive than simple drying. Cycle times can range from hours to several days depending on load, container, and formulation. Amorphous materials may require excipients that help preserve structure during freezing and drying. The method is widely used for biological materials, pharmaceuticals, and foods where heat drying would cause unacceptable change. Open questions remain about scaling cycles between laboratory and production equipment, and this gap affects technology transfer.
Lyophilization removes water by freezing a material and then lowering pressure so ice changes directly to vapor. The process relies on sublimation, the phase transition from solid to gas without an intermediate liquid state. Because the material remains frozen during primary drying, the structure often stays porous. This porous matrix can rehydrate quickly when water is added back. The low pressure also allows vapor to leave the solid matrix without boiling.
A typical cycle begins with freezing, which fixes the material into a solid and determines ice crystal size. Primary drying then raises heat under vacuum so ice sublimes, often near or below the collapse temperature of the formulation. Secondary drying removes bound water that remains after ice is gone, usually by gently warming the product. Each stage balances heat input against pressure to avoid melting or structural damage. Temperature probes and pressure sensors guide the transition between stages.
| Property | Value | Notes |
|---|---|---|
| Typical storage temperature | 2–8 °C | Common for biological materials; some require −20 °C or colder |
| Residual moisture specification | 0.5–3.0% w/w | Product-specific; measured after drying |
| Common moisture method | Karl Fischer titration | Coulometric or volumetric; detects water content |
| Cake appearance | Uniform and porous | Collapse, meltback, or cracks are deviations |
| Reconstitution time | Seconds to several minutes | Depends on formulation, cake structure, and diluent |
== Team appearances == World Cup (representing South Africa): 1956, 1957, 1958, 1959, 1960, 1962, 1963, 1964, 1965 (winners, individual winner), 1966, 1967, 1968, 1971, 1972, 1973, 1977 (individual winner) Slazenger Trophy (representing British Commonwealth and Empire): 1956 Chrysler Cup (representing the International team): 1986 (captain), 1987 (captain, winners), 1988 (captain), 1989 (captain), 1990 (captain), 1991, 1992, 1993, 1994 (winners) Dunhill Cup (representing South Africa): 1991 Alfred Dunhill Challenge (representing Southern Africa): 1995 (non-playing captain, winners) UBS Cup (representing the Rest of the World): 2001 (captain), 2002 (captain), 2004 (captain) Insperity Invitational – Greats of Golf: 2012 (winners), 2014 (winners), 2015 (winners), 2017 (winners)
Aminoacyl-tRNA synthetase enzymes consume ATP in the attachment tRNA to amino acids, forming aminoacyl-tRNA complexes. Aminoacyl transferase binds AMP-amino acid to tRNA. The coupling reaction proceeds in two steps: aa + ATP ⟶ aa-AMP + PPi aa-AMP + tRNA ⟶ aa-tRNA + AMP The amino acid is coupled to the penultimate nucleotide at the 3′-end of the tRNA (the A in the sequence CCA) via an ester bond (roll over in illustration). Transporting chemicals out of a cell against a gradient is often associated with ATP hydrolysis. Transport is mediated by ATP binding cassette transporters. The human genome encodes 48 ABC transporters, that are used for exporting drugs, lipids, and other compounds.
Alyx Vance was created for the video game Half-Life 2, and her design was created by Dhabih Eng. Her motions are performed by actress Jamil Mullen, who also provides the face design. She is voiced by Merle Dandridge in Half-Life 2 and its episodes, and Ozioma Akagha in Half-Life: Alyx. According to Half-Life writer Marc Laidlaw, the relationship between Alyx and the G-Man was based on the relationship between Elena Hausmann and Slowstop from his novel The Third Force: A Novel of Gadget (1996), based on Synergy's computer game Gadget: Invention, Travel, & Adventure (1993).
=== Off-label drugs === Acetazolamide (Diamox) – carbonic anhydrase inhibitor Atomoxetine (Strattera) – norepinephrine reuptake inhibitor (NRI) Eszopiclone (Lunesta) – GABAA receptor positive allosteric modulator and nonbenzodiazepine/Z-drug Oxybutynin (Ditropan) – muscarinic acetylcholine receptor antagonist (anticholinergic) Pimavanserin (Nuplaizid) – serotonin 5-HT2A receptor antagonist Sodium oxybate (GHB; Xyrem) – GABAB receptor agonist and GHB receptor agonist Trazodone (Desyrel) – various actions Weight-loss drugs (e.g., liraglutide, semaglutide) – obesity-related sleep apnea
=== Adoption in precolonial scholarship === The earliest attempt to associate the people of the Gold Coast with ancient Ghana had been made by Rev. J. B. Anaman around the turn of the 20th century. Anaman drew on W.D. Cooley's 19th-century interpretation of Arabic geographical sources to make an argument for a historical connection, suggesting an alternative derivation connecting the name to the Wangara people. Lady Flora Shaw later compiled both Arabic and European writings to create detailed narratives of the kingdom. She presented it as a major African power comparable to contemporary Western European states. According to Jack Goody, the theory that the Akan peoples originated from the medieval Empire of Ghana was continuously promoted through the teachings of Rev. W. T. Balmer between 1907 and 1911, who instructed students that the Akan had migrated from the ancient kingdom located near the Upper Niger. Goody states that Balmer's hypothesis lacked linguistic and historical evidence, yet it later became influential among educated elites and nationalist intellectuals. The hypothesis gained more popularity when it was introduced into educational institutions, primarily in Achimota, during the 1920s where it later spread to other schools. The theory was later publicized by J. B. Danquah's academic writings; he used Arabic and French translations to claim that the Akan migrated from the Upper Niger region. Danquah proposed that the term Ghana was a corruption of Akane or Akana and associated it with the ancient region of Akkad. Eva L. R.
Sources: en.wikipedia.org
It is an epiphytic and occasionally a lithophytic plant, forming spectacular root bundles. Its cylindric pseudobulbs can grow to a length of 2.5 m. It can grow to gigantic clusters weighing from several hundred kilograms to more than one tonne. One collected in 1893 by Frederick K. Sander & Co. near Penang Island in Malaysia weighed 1 t (0.98 long tons; 1.1 short tons). Half was sent to the Columbian Exhibition in Chicago and the other half to the Singapore Botanic Garden. By 1902, the Singapore specimen had grown to be 14.4 m (47 ft) girth by 3 m (9.8 ft) high, and bore simultaneously 2,090 12.5 cm (4.9 in) wide gold and mahogany-coloured flowers plus 1110 unopened buds. Much more recently, in A.D. 2000, biologists Tim Laman and Phil Atkinson found one in Borneo 7.7 m (25 ft) wide and bearing between 2500 and 5000 flowers. The plant completely encircled the host tree 46 m (151 ft) above the ground. The oldest known individual orchid plant is also a G. speciosum. Planted in the Singapore Botanic Garden in 1861 by Garden Director Lawrence Niven and his staff, it was 154 years old in 2015. The plant is also 5 m (16 ft) in width. Each raceme can grow to a height of 3 m, bearing up to 80 flowers, each 10 cm wide. The flowers are yellow with maroon or dark red spots. These flowers are unusual, since the lowest flowers have no lip and these flowers function as osmophores for the entire inflorescence and continue to emit chemical scent to attract pollinators as flowers open in succession. It blooms only once every two to four years.
The two substrates of this enzyme are L-α-glycerophosphoric acid, and oxidised nicotinamide adenine dinucleotide (NAD+). Its products are dihydroxyacetonephosphoric acid, reduced NADH, and a proton. The enzyme can also use the alternative cofactor, nicotinamide adenine dinucleotide phosphate. This enzyme belongs to the family of oxidoreductases, specifically those acting on the CH-OH group of donor with NAD+ or NADP+ as acceptor. The systematic name of this enzyme class is sn-glycerol-3-phosphate:NAD(P)+ 2-oxidoreductase. Other names in common use include L-glycerol-3-phosphate:NAD(P)+ oxidoreductase, glycerol phosphate dehydrogenase (nicotinamide adenine dinucleotide, (phosphate)), glycerol 3-phosphate dehydrogenase (NADP+), and glycerol-3-phosphate dehydrogenase [NAD(P)+]. This enzyme participates in glycerophospholipid metabolism.
===== Non-lytic insect cell expression ===== Non-lytic insect cell expression is an alternative to the lytic baculovirus expression system. In non-lytic expression, vectors are transiently or stably transfected into the chromosomal DNA of insect cells for subsequent gene expression. This is followed by selection and screening of recombinant clones. The non-lytic system has been used to give higher protein yield and quicker expression of recombinant genes compared to baculovirus-infected cell expression. Cell lines used for this system include: Sf9, Sf21 from Spodoptera frugiperda cells, Hi-5 from Trichoplusia ni cells, and Schneider 2 cells and Schneider 3 cells from Drosophila melanogaster cells. With this system, cells do not lyse and several cultivation modes can be used. Additionally, protein production runs are reproducible. This system gives a homogeneous product. A drawback of this system is the requirement of an additional screening step for selecting viable clones.
Biden also faced significant opposition from uncommitted voters and the Uncommitted National Movement in their protest vote movement against Biden due to his support for Israel during the Gaza war, which collectively won 36 delegates. Following a "disastrous" June 2024 debate performance against Trump that "inflamed age concerns", Biden ultimately withdrew from the race on July 21, 2024, and immediately endorsed Kamala Harris to replace him in his place as the party's presidential nominee. Harris quickly announced her own presidential campaign later that day and by the next day, Harris had secured the non-binding support of enough uncommitted delegates that were previously pledged to Biden to make her the party's presumptive nominee. Biden's withdrawal made him the first eligible incumbent president since Lyndon B. Johnson in 1968 not to seek re-election, and the first to withdraw after securing enough delegates to win the nomination. Harris is the first presidential nominee who did not participate in the presidential primaries since Vice President Hubert Humphrey, also in 1968, and the first since the modern Democratic Party primary procedure was created in 1972 (prior to which most states did not hold primary elections). On August 5, 2024, after five days of online balloting, Democratic National Convention delegates voted to make Harris the party's 2024 presidential nominee. She selected Minnesota Governor Tim Walz as her running mate the following day and accepted the party's nomination on August 22.
== History == In October 1967, Techtron Pty Ltd merged with Varian Associates. Techtron is a manufacturer of Atomic Absorption Spectrometers and Spectral lamps. In 1982, Varian transferred the Cary UV-Visible product line to Australia. In 1997, Varian bought Chemagnetics, a Colorado-based manufacturer of solid-state NMR spectrometers. In 2002, Varian bought Ansys Technologies, Inc., a California-based manufacturer of In-Vitro Medical Devices. In 2004, Varian Inc bought Magnex Scientific, an Oxford-based manufacturer of high-field magnets. In 2005, Varian bought Polymer Laboratories, a speciality polymer analysis and manufacturing company. In 2006, Varian bought Ion Spec, an FTMS (Fourier Transform Mass Spectrometry) manufacturing company. In 2007, Varian, Inc. bought Analogix, Inc., a company specializing in flash chromatography. In 2008, Varian bought Oxford Diffraction, a British company specializing in X-ray diffraction equipment. On 27 July 2009, Agilent Technologies announced it would buy Varian Inc, for $1.5 Billion. On 14 October 2014, Agilent made the strategic decision to close its NMR business. Agilent entered the NMR business in 2010, with the acquisition of Varian. Several former Varian engineers have continued the business through private ventures, including the probe department spawning the company PhoenixNMR and the software being made open source.
Sources: en.wikipedia.org
Most are held in sealed containers at controlled temperatures, often 2–8 °C, while some require frozen storage. Protection from moisture and light helps preserve the dry matrix. Exact conditions are set by the manufacturer or study protocol.
Cake collapse suggests the material exceeded its collapse temperature during drying or later absorbed moisture. It can lead to slower reconstitution, uneven moisture, and reduced stability. Appearance alone may not reveal the cause, so process records and moisture tests are used together.
Some residual moisture is common and may be acceptable within a defined range. Very low moisture can alter stability or increase brittleness, while high moisture promotes hydrolysis and microbial risk. Specifications are based on product-specific stability data.
Primary drying removes ice by sublimation under vacuum. Secondary drying removes water that is bound to the material, often by warming the product after most ice has left. Both stages occur below temperatures that would cause unwanted melting.